ghi_tx001160gb.fm
32
Lifting and Transporting E 3000
3.3 Transporting the Machine on a Truck or Trailer
Requirements
Machine stopped. See topic Stopping the Machine.
All doors and access covers closed and secured.
NOTICE: Do not run chains or straps across painted surfaces. Chains or straps
may damage your machine.
Move the
machine
1. Move the machine onto the flat bed using properly rated ramps or docks.
NOTICE: The flat bed must be at least 98 inches wide.
Support the
tongue
2. Raise the tongue using the trailer jack (a).
3. Install the tongue support (b) using two 5/8 inch bolts.
NOTICE: If the supplied tongue support is missing, use any mechanism capable of
supporting the tongue weight.
4. Lower the tongue and retract the trailer jack (a) at least two inches from the
surface of the truck bed.
This procedure continues on the next page.
WARNING
Crushing hazard. Improperly securing the machine can lead to a crushing hazard.
f Use only the designated tie-down points to secure the machine.
To Next Page
Loading...
