wc_tx001951gb.fm
61
E 3000 Operation
4.20 Initiating HTF Flow
Requirements
Heat Transfer Fluid (HTF) preheated. See topic Preheating the HTF.
Gloves
Note: If you are using accessories, see Chapter “Accessories”.
Procedure
Follow the procedure below to initiate HTF flow.
1. Close and lock valve #3. This is the fill valve.
v
2. Open valve #2. This is the suction valve.
3. Open valve #4 and valve #6. These are the hose reel supply valves.
This procedure continues on the next page.
CAUTION
Burn hazard. The hoses and components of the plumbing system may be very hot.
Hot hoses and hot plumbing components may cause burns.
f Wear gloves when handling hot hoses or hot plumbing components.
To Next Page
Loading...
