Wacker Neuson E3000 User Manual

wc_tx001951gb.fm
59
E 3000 Operation
4.18 Applying Power to the Machine
Requirements  Pre-starting checks have been completed
 Power connected to the machine
Procedure Follow the procedure below to apply power to the machine.
1. Move both circuit breaker switches (a) to the ON position.
2. Check that the indicator lights of both GFCIs (b) are off. Press the “RESET”
button of the GFCI if its indicator light is ON.
3. Check that the low-level-fault indicator light (c) is OFF. If this light is ON, add
Heat Transfer Fluid (HTF) to the reservoir. See topic Filling the HTF Reservoir.
4. Check that the displays of the temperature controller (d) illuminate. If the
displays of the temperature controller do not illuminate, there is a problem with
the GFCI 1 or with the wiring to the temperature controller. Disconnect the main
power supply and rectify the problem before continuing.
Result The machine is ready for operation.
wc_gr008607
1
2

Wacker Neuson E3000 Specifications

General

Electrical Requirements	230 V, 50 Hz
Voltage	230 V
Operating Voltage	230 V
Heat Capacity	3000 W
Fuel Consumption	0.3 l/h
Tank Capacity	12 l
Fuel Tank Capacity	12 l
Heating Capacity	3000 W
Fuel Consumption (l/h)	0.3 l/h
Tank Capacity (l)	12 l
Power Consumption	3 kW