64
VERSION 03/2020 ORDER NUMBER DOC2330732
VU 1/VU 2/VU 3
11 DISASSEMBLY AND DISPOSAL
11.1 DISASSEMBLY
WARNING
Incorrect disassembly!
Risk of injury and damage to the device.
Before starting disassembly:
– Switch o the energy and compressed air supply.
– Ensure that all system components are grounded.
– Secure system against being switched back on without authorization.
Observe the operating manuals when carrying out all work.
We recommend having the WAGNER system disassembled by WAGNER or another specialist.
Before starting disassembly, all supply media (electric current, compressed air) must be
disconnected at the connection points. All powder lacquer lines must be completely
emptied and then rinsed. Lacquer residues must be disposed of in line with statutory
requirements.
Before starting disassembly, check whether the supply lines have actually been interrupted
and have been depressurized and/or de-energized if necessary.
The empty system should be thoroughly cleaned. In particular re loads such as unused
lacquers in exhaust air pipes etc. should be removed to keep the risk of re during
disassembly as low as possible.
We recommend reporting to the public authorities the fact that systems with mandatory
approval requirements are decommissioned.
Separate all materials encountered during disassembly as clearly as possible in line with
statutory requirements. Carry out appropriate measures to ensure that no dangerous
substances can enter the system as it is being disassembled. All waste produced must be
separated and disposed of in line with local requirements.
Used materials are:
– Steel
– Plastics
– Cables …
To Next Page
Loading...
