WAGNER VU 1 - Correct Use; Device Type; Type of Use; For Use in Potentially Explosive Areas

9
VERSION 03/2020 ORDER NUMBER DOC2330732
VU 1/VU 2/VU 3
2 CORRECT USE
2.1 DEVICE TYPE
Reciprocator suitable for use in automatic powder coating systems.
2.2 TYPE OF USE
The VU 1/VU 2/VU 3 reciprocator serves to continuously move the powder spray guns,
attached to the gun mountings, up and down or to position them at a specic height.
The dierent types of gun mountings and their associated counterweights and fastening
elements are listed in chapter 12. The lifting and lowering speed and the lifting height
can be steplessly adjusted via the corresponding controller.
The device may only be operated under the following conditions:
Use the device only to work with the products recommended by WAGNER.
Do not deactivate safety xtures.
Use only WAGNER original spare parts and accessories.
The operating personnel must be trained on the basis of this operating manual.
Follow the instructions in the operating manual.
2.3 FOR USE IN POTENTIALLY EXPLOSIVE AREAS
The VU 1/VU 2/VU 3 reciprocator can be used in areas subject to explosion hazards (Zone 22)
(see Explosion Protection Identication, Chapter 3.1).
In explosion hazard areas, only use approved explosion-proof electrical devices.
2.4 PROCESSIBLE WORKING MATERIALS
– types of powder that can be charged electrostatically;
– metallic powder.
Note:
Contact your local WAGNER dealer and the lacquer manufacturer if you encounter application
problems.
2.5 MISUSE
Misuse can lead to physical injury and/or property damage!
Special attention must be paid that:
liquid coating products, e.g., solvents or water-based lacquers are not processed;
no food, medicine or cosmetics are processed.