Preface
Operator’s manual 2.1
11
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
2.1.3.1
Explanation of symbols
Symbol for warning notices
This symbol is a warning symbol. It is used to alert you to
potential hazards. The safety symbol is always followed by
a signal word, which indicates the hazard. These warnings
are to be observed in particular. This protects the operator
and third parties from personal injury and damage to prop-
erty.
Symbol for environmental information
This symbol indicates environmental information. It is used
to warn of possible environmental hazards.
Symbol for information
This symbol indicates information. This information can in-
clude tips on operation, for example. It helps to better un-
derstand and use the machine.
Symbol for compliance with EC directives
The CE mark documents that the machine complies with
the valid EC directives.
2.1.3.2
Abbreviations
Abbreviations that may be used in the instructions are listed below. When
an abbreviation is used for the first time, it is first written out in full and the
abbreviation is placed in brackets. Common abbreviations (e.g., etc.) are
not explained. If necessary, a brief explanation is placed in brackets.
Abbreviation Meaning
Fig. Number of the figure beneath an illustration
ABE National Type Approval (Germany)
GTC General terms and conditions
ATF Automatic Transmission Fluid (lubricating oil in the axles)
o/h Operating hours
DOC Diesel Oxidation Catalyst (component in the system for exhaust gas aftertreatment)
DPF Diesel particulate filter (component in the system for exhaust gas aftertreatment)
EBE Authorization for stand-alone operation
ECS Emission Control System (control of exhaust gas aftertreatment)
ECU Electronic Control Unit (electronic control unit in the vehicle)
EC European Community
EGR Exhaust Gas Recirculation
FOPS Falling Object Protective Structure
LED Light-emitting diode
LWA Sound power level
MVCU Multi Variable Control Unit (electronic control unit in the vehicle)
ROPS Roll Over Protection Structure
SAE Society of Automotive Engineers (viscosity class of engine oil)
SCR Selective Catalyst Reduction (exhaust gas aftertreatment with urea)
2
To Next Page
Loading...
