Operation
7.9 Operating the front hydraulic connections
138
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Switch off continuous operation of hydraulic connections
If continuous operation is no longer needed, proceed as follows:
▪ Move the switch to position 0.
ð Symbol
illuminates in the display.
ð Continuous operation is switched off.
7.9.4
Operating additional hydraulic connections
Fig.125: Hydraulic connections addi-
tionally on the loader unit
With the fourth control circuit function, the additional hydraulic connec-
tions on the loader unit can be operated. This function is necessary if the
standard hydraulic connections are not sufficient for certain attachments.
To Next Page
Loading...
