Operation
Working with attachments 7.12
155
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
Fig.152: Scraping work
Scraping work
1. Set a flat digging angle.
2. Fold up the front half of the bucket by about 10 to 15cm.
3. Lower the bucket to the ground.
4. Set the depth of the layer you want to remove with the lift hydraul-
ics.
5. Pick up material by performing forward vehicle travel.
ð The material rolls into the bucket and is picked up at the same time.
This position allows to strip grass turf, e.g. down to a thickness of about 8
cm
Fig.153: Spreading material
Spreading material in thin layers
1. Fill bucket with material to be spread.
2. Open the bucket according to the material and flow rate.
ð Spread the material evenly on the surface.
7.12.7
Using the manure fork
Practice using the manure forks before working with them for the first
time.
Designated use
The manure fork attachment is used for loosening, picking up, transport-
ing and loading material such as silage, hay, round bales, green fodder
and manure.
7
To Next Page
Loading...
