Operation
7.12 Working with attachments
156
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Fig.154: Loading with the manure
fork
Working with the manure forks
1. Lower attachment.
2. Set the attachment parallel to the ground.
3. Drive into the material to be loaded.
ð Pay attention to the travel speed.
4. Slightly raise the loader unit.
ð A load is applied to the front axle of the vehicle.
ð The wheel slip can be reduced manually by inching.
For solid materials, such as solidified manure in stables, the load can be
loosened by tilting in the attachment.
1. Travel to the unloading position in a straight line.
2. Lift the attachment to the required height just before the unloading
position.
3. Drive forward as far as necessary.
4. Empty attachment.
ð The material falls out.
7.12.8
Using the fork and grab
Practice using the fork-and-grab attachment before working with it for the
first time.
Designated use
The fork-and-grab attachment is used for picking up, transporting, loading
and spreading loose material such as silage, hay, straw, green fodder
and manure. The transportation of tree trunks, stones and similar materi-
als as well as persons does not constitute intended use.
To Next Page
Loading...
