Maintenance
9.6 Checking fill levels
192
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
9.6.5
Fill level of hydraulic oil
NOTICE
Damage to hydraulic system due to incorrect fill level!
► The hydraulic oil level must never fall below the MIN mark on the oil
dipstick.
► When filling, never exceed the MAX mark on the oil dipstick.
► Check fill level regularly.
► Do not use the vehicle if the fill level is not correct.
NOTICE
Damage to the hydraulic system due to incorrect or contaminated
hydraulic oil!
► Only use approved hydraulic oil.
► Oil turbidity means that there is water or air in the hydraulic system
which can damage the hydraulic oil pump. Have the problem only
rectified by an authorized service center.
► Do not use the vehicle until the fault has been rectified.
Preparation for maintenance In the engine compartment
1. Park the vehicle on a stable, level and dry surface.
2. Secure the vehicle with the parking brake.
3. Retract the loader unit and lower it to the ground.
4. Switch off the ignition and remove the starting key.
5. Let the engine cool down.
6. Open the engine cover.
To Next Page
Loading...
