Weidemann Basic line 4080T - Page 81

Commissioning
Setting up the operator station 6.2
81
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
NOTICE
Damage to the compressor.
Too long operation of the suspension adjustment can cause damage to
the compressor.
► Do not operate the suspension adjustment for more than one minute.
The individually desired height can be adjusted up to a minimum spring
travel.
ü The ignition must be switched on.
1. Pull lever 3 upward.
ð The seat moves upwards and the suspension travel increases.
2. Push lever 3 down.
ð The seat moves downwards, the suspension travel becomes
smaller.
3. Release lever 3 when the seat has reached the desired position.
ð Suspension and height are adjusted.
Activating/deactivating horizontal suspension
Specific operating conditions may require switching on the horizontal sus-
pension. The horizontal suspension absorbs shocks that can occur during
braking and acceleration of the vehicle.
▪ Lever 4 forward.
ð Horizontal suspension is switched on.
▪ Lever 4 to the rear.
ð Horizontal suspension is switched off.
Adjusting the backrest
1. Pull lever 5 upward and hold.
2. Move the backrest forwards or backwards until the desired inclina-
tion of the backrest is reached.
3. Release lever5.
After adjustment, lever 5 must engage in the desired position. Once it is
locked in place the backrest must no longer move.
6.2.1.2
Seat MSG85
Sit on the seat to adjust.
6