TESTING
FOR
OVERHAUL
5. Perfonn disassembly
in
a proper order using proper tools.
Keep disassembled parts
in
order. Apply oil when neces-
sary. Take special care to keep the fuel system parts free
from the intrusion
of
dust and dirt.
Reassembly
1. Prepare
all
parts necessary for reassembly.
2.
Clean or wash the parts. Apply oil on surfaces where
needed or specified.
3. Carefully check gaskets, packings and oil seals even
if
not specified
to
check. Replace with new ones if defec-
tive.
4. Be sure to install
in
proper directions and positions.
(Pay attention to dowel pins, mating marks and specified
directions.) Where tightening torque is not specified,
tighten evenly to an ordinary torque. Apply sealant where
specified.
5. After completion
of
the reassembly, manually rotate the
engine crankshaft two complete revolutions
to
ensure
there is no binding
or
obstructions. Prepare for starting
the engine and idle the engine sufficiently for a test run.
Engines & Generators
7
To Next Page
Loading...
