Westerbeke W-27 Service Manual

CYLINDER BLOCK SERVICE
INSTALLING GEAR CASE
22. Insert the crankshaft pulley. Install the washer and nut.
Then tighten to the specified torque.
23. Install the back plate. Be sure to install the gasket.
24. Install the oil pick up, then install the oil pan.
25. Apply oil to the periphery
of the tappet. Insert the tappet
into the cylinder block. Then insert the push rod properly
into the tappet hole. Check to see
if the tappet moves
lightly.
PUSH ROD
INCORRECT
CORRECT
INSTALLING TAPPET AND PUSH ROD
26. Install the cylinder head assembly (see CYLINDER
HEAD SERVICE, REASSEMBLY).
27. Install the injection pump assembly (see Installation and
Adjustment of Fuel Injection Pump under FUEL
SYSTEM).
INSTALLING INJECTION PUMP
28. Install the oil pump and oil filter (see REASSEMBLY
under LUBRICATION SYSTEM SERVICE). When the oil
pressure switch and oil pressure sender with adapter has
not yet been installed, apply sealant to the threaded por-
tion when installing.
29. Install the fuel filter.
30. Install the fresh water pump.
31. Install the starter (see
STARTER/SOLENOID SERVICE)
and alternator (see ALTERNATOR/REGULATOR SER-
VICE).
32. Install the raw water pump.
Engines & Generators
30

Westerbeke W-27 Specifications

General

Brand	Westerbeke
Model	W-27
Category	Engine
Language	English