PROCEDURE
1 Remove the water guide jacket.
1.1 If necessary, attach the lifting tools (002, Figure 7-2) to the lifting tool (001) as
follows:
1.1.1 Make sure that the shackle (011) is attached to the middle hole in the
lifting tool (001).
1.1.2 Attach the two lifting tools (002) to the lifting tool (001) with the eight nuts
and bolts (003).
1.1.3 Tighten the eight nuts and bolts (003).
1.2 Attach the two eye bolts (007) to the water guide jacket (010).
1.3 Attach the two shackles (006) to the eye bolts (007)
1.4 Attach the two slings (005) to the shackles (004).
1.5 Remove the two bolts (015)
1.6 Remove the two bolts (009).
1.7 Remove the holder (008).
1.8 Remove the four bolts (012).
1.9 Remove the pipe connections (013).
1.10 Remove the tubes (014).
NOTE: The tubes are a push-fit in the pipe connections (013).
1.11 Attach the engine room crane to the shackle (011) on the lifting tool (001).
1.12 Operate the engine room crane to move the lifting tool (001) into position above
the water guide jacket (013).
1.13 Attach the two slings (005) to the shackles (006).
1.14 Operate the engine room crane to hold the weight of the water guide jacket
(010).
1.15 Remove the three bolts (016).
1.16 Remove the eight bolts (017) and the three holders (018).
1.17 Operate the engine room crane to lower the water guide jacket (010) on to the
cylinder block.
X72DF
AA00-2124-00AAA-520A-A
Maintenance Manual Cylinder liner - remove
Winterthur Gas & Diesel Ltd.
- 173 - Issue 002 2020-10
To Next Page
Loading...
