12 Group 7 - Cylinder lubrication and
balancer
12.1 Cylinder lubrication system
12.1.1 Cylinder lubrication system - do a functional test.........................670
12.1.2 Cylinder lubrication system - bleed.....................................672
12.1.3 Cylinder lubricating pump - remove.................................... 676
12.1.4 Cylinder lubricating pump (MK-1) - examine.............................680
12.1.5 Cylinder lubricating pump (MK-E) - do a service......................... 682
12.1.6 Cylinder lubricating pump - install......................................686
12.2 Integrated electric balancer (iELBA)
12.2.1 Integrated electric balancer - prepare before the bearings removal.........688
12.2.2 Integrated electric balancer - remove the bearing (engine side)............690
12.2.3 Integrated electric balancer - remove the bearing (outer side)............. 694
12.2.4 Integrated electric balancer - do a check of the bearing clearance..........698
12.2.5 Integrated electric balancer - adjust the bearings........................ 702
12.2.6 Electric balancer sensor unit - remove the proximity sensor............... 706
12.2.7 Electric balancer sensor unit - install the proximity sensor.................708
12.2.8 Integrated electric balancer - do a check of the backlash..................710
12.2.9 Integrated electric balancer - install the bearing (engine side)..............714
12.2.10 Integrated electric balancer - install the bearing (outer side)...............716
X72DF
Maintenance Manual
Winterthur Gas & Diesel Ltd.
- 669 - Issue 002 2020-10
To Next Page
Loading...
