PROCEDURE
1 Install the CCM-20.
2 Connect the power supply to the CCM-20.
3 After a reboot of the CCM-20, the ECS activates a software download.
NOTE: You can monitor the software download on the LDU-20 at the local control
panel.
4 If applicable, start the engine, refer to the Operation Manual.
NOTE: The engine does an air run to find the crank angle for the installed CCM-20.
After the air run, the engine will do a standard start.
CLOSE UP
• None
X72DF
AA00-9606-00ABA-720A-A
Maintenance Manual CCM-20 - install
Winterthur Gas & Diesel Ltd.
- 815 - Issue 002 2020-10
To Next Page
Loading...
