WORKSWELL WIRIS PRO - Help and FAQ; General Instructions

2. WARNING AND CAUTIONS
2 Warning and Cauons
2.1 Warnings
Before using the product, please read the whole User Manual. Before power‐up the camera or drone, please
check that there is no visible damage or malfuncon, cables are connected properly and verify the polarity is
correct.
If there are any visible signs of damage or other defect on the device, or you are not sure with the connecon,
then on no account should it be installed or put into operaon.
Any interference and non‐cered service operaons into the product leads to an automac loss of warranty.
2.2 Nocaons
Do not use or store the device in conict with the storage and operang condions laid down in this manual
(only for hardware).
Do not point the infrared camera (with or without the lens cover) at strong energy sources, for example,
devices that cause laser radiaon, or the sun. This can have an unwanted eect on the accuracy of the
camera. It can also cause damage to the detector in the camera.
Plug the camera to its own power source. Do not plug the camera into the same power source as drone’s
motors.
Use original accessories only.
Do not plug any power to the GPS/Mavlink power pin.
Do not use the Workswell WIRIS Pro system in temperatures higher than +50
◦
C (+122
◦
F). High tempera‐
tures can cause damage to the camera.
Do not use the Workswell WIRIS Pro system in temperatures lower than ‐10
◦
C (+5
◦
F). Low temperatures
can cause damage to the camera.
Do not use the Workswell WIRIS Pro in environmental condions that make condensaon possible (make
sure the air is non‐condensing)
Do not apply solvents or equivalent liquids to the cameras, the cables, or other items. Damage to the items
can occur. For cleaning refer to chapter 20.
Be careful when you clean the infrared lens. The lens has an an‐reecve coang which is easily damaged.
Do not use too much force to clean the infrared lens. This can cause damage to the an‐reecve coang.
The encapsulaon rang is only applicable when all the openings on the all components of the system are
sealed with their correct covers, hatches, or caps.
E‐mail and Web
info@workswell.eu
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Version: 201215 EN, 15
th
Dec, 2020
All pictures are only for illustraon.
Real values may vary.
5