Xerox 4112 - E-mail print; Sending e-mails

Xerox 4112/4127 Copier/Printer 9-1
System Administration Guide
9
Setups
The machine has factory default (initial) settings which can be customized. To change the
settings, enter the System Administration mode and use the System Settings screen. This
chapter describes how to change system settings.
Tip
The User Interface (UI) screens shown in this guide may or may not reflect the screens
displayed on your system. The UI screens vary from system to system and from marketplace to
marketplace. Therefore, the UI screens in this guide are a representation of the type of screens
that may be seen on your particular system.
System settings procedure
This section describes the basic procedure for changing system settings. To make or change the
system settings, it is necessary to be in System Administration mode.
1. Enter the System Administration mode (Chapter 1 Entering the System Administrator mode
on page 1-10).
2. From the System Settings screen, select a group.
Note
For the items that can be selected in the system settings, refer to System Settings on page
12-1.
3. Select a feature. After setting the feature, select Save.
4. Exit the System Administration Mode: (Chapter 1 Exiting the System Administrator mode
on page 1-11)
Downloaded From ManualsPrinter.com Manuals