Product Overview
1-12 System Administration Guide
Xerox 4112/4127 Copier/Printer
Notes
• Enter addresses in the format “xxx.xxx.xxx.xxx” where xxx should be a numeric value in
the range from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot
be used.
• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 248, 252,
and 255. However, you cannot use 0 between non-zero values.
• If you do not wish to set the gateway address, enter “0.0.0.0.”
10. Select Close repeatedly until the System Settings screen is displayed
Power Saver Mode
The machine is installed with a Power Saver feature that will automatically cut off the electricity
to the machine if no copy or print data is received for a certain duration.
The Power Saver feature has two modes, a Low Power mode and Sleep mode. The machine
enters the Low Power mode after the preset time has elapsed if the machine is left unused for a
fixed period of time.
The machine then enters the Sleep mode if a further preset time elapses.
Low Power Mode
In this mode, the power to the UI and fuser unit is lowered to save power. The display goes out,
and the Power Saver button on the Control Panel lights. To use the machine, press the Power
Saver button. The Power Saver button goes out to indicate that the Power Saver feature is
canceled.
Sleep Mode
In this mode, the power is lowered more than in the Low Power mode. The display goes out,
and the Power Saver button on the Control Panel lights. To use the machine, press the Power
Saver button. The Power Saver button goes out to indicate that the Power Saver feature is
canceled.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
