Configuration
Xerox 4112/4127 Copier/Printer 2-3
System Administration Guide
NetWare
Preparations
The following items are required when using NetWare network:
•A NetWare server.
• The "CentreWare Utilities" CD-ROM which is included with this product.
Configuration procedure
Overview
The machine supports PServer mode for both the NetWare Directory Service and Bindery
Service. PServer mode enables the machine to function as a print server and to capture print
jobs in the print queue to output. The printer created for the machine consumes one file server
license.
Note
The machine does not support Remote Printer (RPrinter) Mode.
Supported interfaces
•100Base-TX
•10Base-T
Supported frame types
• Ethernet II specification
• IEEE802.3 specification
• IEEE802.3/IEEE802.2 specification
• IEEE802.3/IEEE802.2/SNAP specification
Note
The machine will send packets of each frame type on the network, and will initialize for the
same frame type as the first reply packet received. However, if there are multiple protocols
running on the same network, use Ethernet II specification.
Configuration on the machine (NetWare)
This section describes the configuration procedure to connect the machine to a NetWare
network.
Note
Configuration can also be performed using the Network configuration tools included in
CentreWare Internet Services or CentreWare Utilities. Refer to “Using CentreWare Internet
Services”.
1. Confirm the device name and network address.
Print the Printer Settings List to confirm the device name and network address printed
under the NetWare item.
2. Configure the machine using the “CentreWare Utilities” CD-ROM.
There is no need to activate the NetWare port on the machine prior to configuration when
using the “CentreWare Utilities” CD-ROM.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
