Setups
Xerox 4112/4127 Copier/Printer 9-79
System Administration Guide
Offset Stacking (Middle Right Tray)
Select the default offset stacking option for the finisher tray:
• None: If this option is selected, the finishing tray will not offset any output.
• Offset per set: If this option is selected, the finishing tray will offset each set of a copy/
print job. This option also offsets each job.
• Offset per job: If this option is selected, all the sets of a job are delivered on one stack to
the output area. When the next job starts, that job is offset from the previous job in the
tray. This option does not offset each set of a job.
Auto Job Promotion
This Other Settings option allows you set the machine to automatically promote a job for
printing/copying if the machine is unable to start a prior job. For example, the machine is
unable to start an operation because there is no paper in the tray (at the start of a copy or print
operation). If this feature is enabled, then the machine can bypass the current job and allows
other jobs to start.
Tip
The other jobs must not have the same copy/print requirements as the faulted job. If other
jobs have different copy/print requirements, then these other jobs can be promoted and
copied/printed.
3 sets of another job
3 sets
of a
job
3 sets of a job
Job 1
Job 2
(with stacked sets)
(with stacked sets)
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
