Xerox 4112 System Administration Guide

Setups
Xerox 4112/4127 Copier/Printer 9-133
System Administration Guide
Receiving Buffer - LPD Spool
• Off: When Off is selected, the machine will not use spooling. During the LPD print process
for one client, data cannot be received over that same interface from a different client. Set
a value for the dedicated LPD receiving buffer memory capacity from 1024-2048 KB, in 32
KB increments.
• Memory Spool: When selected, the machine will use spooling. The receiving buffer for
spooling uses memory. When this candidate value is selected, set the memory capacity of
the receiving buffer for spooling, from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note
Notice that print data exceeding the set memory capacity is not accepted. In such cases, select
Hard Disk or Off.
• Hard Disk Spool: When selected, the machine will use spooling. The receiving buffer for
spooling uses the hard disk.
Receiving Buffer - NetWare
Set the NetWare receiving buffer. Set a value from 64 to 1024 KB, in 32 KB increments.
Receiving Buffer - SMB Spool
• Off: When Off is selected, the machine will not use spooling. While SMB print processing is
being carried out for one client, data cannot be received over the same interface from
another client.
Set a value for the dedicated SMB receiving buffer memory capacity from 64 to 1024 KB, in
32 KB increments.
• Memory Spool: When selected, the machine will use spooling. The receiving buffer for
spooling uses memory. When this candidate value is selected, set the memory capacity of
the receiving buffer for spooling from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note
Notice that print data exceeding the set memory capacity is not accepted. In such cases, select
Hard Disk or Off.
• Hard Disk Spool: When selected, the machine will use spooling. The receiving buffer for
spooling uses the hard disk.
Receiving Buffer - IPP Spool
• Off: When Off is selected, the machine will not use spooling. While IPP print processing is
being carried out for one client, data cannot be received over the same interface from
another client. Set a value for the dedicated IPP receiving buffer memory capacity from 64
to 1024 KB, in 32 KB increments.
• Hard Disk: When selected, the machine will use spooling. The receiving buffer for spooling
uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer. Set a value from 1024 to 2048 KB, in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port9100 receiving buffer. Set a value from 64 to 1024 KB, in 32 KB increments.
Downloaded From ManualsPrinter.com Manuals

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English