Xerox 4112 System Administration Guide

Configuration
Xerox 4112/4127 Copier/Printer 2-7
System Administration Guide
Configuration on the machine (EtherTalk)
This section describes the configuration procedure to connect the machine to EtherTalk
network.
Enable the EtherTalk port
Note
The configuration can also be performed using CentreWare Internet Services or CentreWare
Utilities. Refer to “Using CentreWare Internet Services”.
Note
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
on page 1-10.)
2. Enable the EtherTalk port.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select EtherTalk and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
5. After the machine is restarted, print out the Printer Settings List to confirm that the
EtherTalk port is enabled.
Note
Configure EtherTalk as necessary. Refer to EtherTalk on page 3-5 for the EtherTalk configuration.
Configuration on the computer
See Chapter 2 Configuration on the computer on page 2-2.
Downloaded From ManualsPrinter.com Manuals

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English