Control Panel Error Messages
Phaser® 6180MFP Multifunction Printer
10-37
NNN indicates a numeric value.
Reboot Printer
116-316
Additional memory (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the additional memory.
Reboot Printer
116-320
An unsupported additional memory (optional) is installed.
Replace the specified additional memory.
NV RAM Error
Error 116-390
Restart Printer
An internal error has occurred.
Restart the printer. If the problem persists, contact Xerox
Technical Support.
Scanner Lamp Error
Error 062-371
Restart Printer
The scan bar lock switch is set to the locked position.
Set the scan bar lock switch to the unlocked position, and then
turn the printer off and then on.
Note: When the printer tries to activate the scan bar when it is
locked, it produces a loud noise.
Set xxxx
XXXXXXXX
Set xxxx
YYYYYYYY
The tray specified by xxxx is out of paper, or the specified paper
could not be detected in the tray.
Fill the tray with the indicated size, direction, and type of paper.
xxx indicates the number of the tray or Tray 1 (MPT). See Loading
Paper in Trays 2 and 3 on page 5-13.
SysError NNN-NNN
Press Set
A system error has occurred.
Press the OK button to clear the message.
Tray Detached
Push in xxxx
Tray xxxx is pulled out.
Set Tray xxxx into the correct position. xxx indicates the number of
the tray.
Wrong Paper Size
Reload xxxx
Set xxxx
XXXX
The correct paper is not set in Tray xxxx.
Set the following size, direction, and type of paper into the tray:
XXXX. xxx indicates the number of the tray or Tray 1 (MPT). See
Loading Paper in Trays 2 and 3 on page 5-13.
Message Condition/Reason/Action
To Next Page
Loading...
Need help?
General
