Setting Paper Types and Sizes
Phaser® 6180MFP Multifunction Printer
5-9
Setting Paper Types and Sizes
Setting Paper Trays
When loading paper in Tray 2 or the 550-Sheet Feeder (optional), it is necessary to set the
paper type on the control panel.
When loading paper in Tray 1 (MPT), set the paper size and type on the control panel when
printing. When MPT Mode has been set to Panel Specified (default) on the control panel, you
can set the paper size and type on the control panel.
This section describes how to set the paper size and type on the control panel.
Note: When you set MPT Mode to Panel Specified, printing will be performed only when
the settings for the paper size and type configured on the print driver match the settings on the
control panel. When the settings on the print driver and control panel do not match, follow the
instructions displayed on the control panel.
You can also display the message to set the paper size and type on the control panel every time
you load paper into each tray.
See also:
Description of Menu Items on page 9-4
Setting Paper Types
Caution: Paper type settings must match those of the actual paper loaded in the trays.
Otherwise, print-quality problems can occur.
1. Press the System button to display the Setup screen.
2. Select
Tray Settings, and then press the OK button.
3. Select the tray, and then press the OK button.
4. Select
Paper Type, and then press the OK button.
5. Select the correct paper type for the loaded paper, and then press the OK button.
Setting Paper Sizes
1. Press the System button to display the Setup screen.
2. Select Tray Settings, and then press the OK button.
3. Select the tray, and then press the OK button.
4. Select Paper Size for Custom Size only, and then press the OK button.
Note: Select Driver Specified when you set a custom size paper from Tray 1 (MPT).
To Next Page
Loading...
Need help?
General
