Description of Menu Items
Phaser® 6180MFP Multifunction Printer
9-6
Tray Settings
There are three submenus under the Tray Settings menu: Tray 1 (MPT), Tray 2, and Tray 3.
You can set paper size and paper type for each tray under these menus. (Display Pop-up and
MPT Mode can only be set for Tray 1 (MPT).)
Tray 3 is displayed only when the optional sheet feeder is installed.
The settings menu for Tray 1 (MPT) is displayed only when the MPT Mode is set to Panel
Specified.
Common Settings for Tray 1 (MPT), Tray 2, and Tray 3
■ Paper Type: Specifies the type of paper loaded in each tray.
■ Tray 1 (MPT) (default: Thin Card Stock)
■ Tray 2 (default: Plain)
■ Tray 3 (default: Plain)
For details, refer to Setting Paper Types and Sizes on page 5-9.
■ Paper Size: Specify the paper size and orientation for each tray.
■ Tray 1 (MPT) (default: Driver Size)
■ Tray 2 (default: Auto)
■ Tray 3 (default: Auto)
For details, refer to Setting Paper Types on page 5-9.
Settings Exclusive to Tray 1 (MPT)
■ Display Popup: Specifies whether or not to display the message that prompts you to set
the paper size and type every time you load paper in Tray 1 (MPT).
When you select On, the message that prompts you to set the paper size and type is
displayed. The default is Off.
■ MPT Mode: Specifies the way to set the paper type and size settings to be loaded in
Tray 1 (MPT). When the size or type of paper that is loaded is different from the setting,
the print quality may suffer or paper may jam. Specify the correct paper type and size.
■ Panel Specified (default): You can specify the paper type and size settings on the
control panel. Printing can be done only when the settings on the print driver match
the settings on the control panel. When a mismatch of paper sizes occurs, follow the
instructions displayed on the control panel.
■ Driver Specified: You cannot specify the settings on the control panel. Printing is
done using the settings on the print driver.
When installing the optional sheet feeders if Paper Tray is set to Auto on the print driver, the
feeding tray is automatically specified according to the setting on the control panel. Also,
when the paper size and type setting for each tray is the same, printing continues by changing
the feeding tray if the paper in the specified tray has run out.
To Next Page
Loading...
Need help?
General
