Choosing a Connection Method
Phaser® 6180MFP Multifunction Printer
4-3
Choosing a Connection Method
Connect the printer via Ethernet, USB, or parallel. A USB or a parallel connection is a direct
connection and is not used for networking. An Ethernet connection is used for networking.
Hardware and cabling requirements vary for the different connection methods. Cabling and
hardware are generally not included with your printer and must be purchased separately. This
section includes:
■ Connecting via Ethernet and USB on page 4-3
■ Connecting via Ethernet on page 4-3
■ Connecting via USB on page 4-4
■ Connecting via Parallel on page 4-5
Connecting via Ethernet and USB
You can connect your Phaser 6180MFP printer through Ethernet, USB, or both at the same
time. The available features for each connection type are shown in the following table.
For information on each connection type, see Connecting via Ethernet on page 4-3 and
Connecting via USB on page 4-4.
Connecting via Ethernet
Ethernet can be used for one or more computers. It supports many printers and systems on an
Ethernet network. An Ethernet connection is recommended because it is faster than a USB
connection. It also allows you direct access to CentreWare Internet Services (IS). The
CentreWare IS web interface enables you to manage, configure, and monitor networked
printers from your desktop.
Connection Type Available Features
USB When connected via USB you can:
■ Scan an image into an application.
■ Scan an image to a folder on the computer.
■ Use the Address Book Editor to manage address book entries.
Ethernet When connected via Ethernet you can:
■ Scan to a computer on the network.
■ Scan to an FTP server.
■ Scan to email.
■ Use CentreWare IS to manage address book entries.
To Next Page
Loading...
Need help?
General
