Adjusting Copying Options
Phaser® 6180MFP Multifunction Printer
6-12
Output Adjustments
You can change the following output adjustment settings:
â– Collating Copies on page 6-12
â– Output Quality on page 6-12
Collating Copies
When you make several copies of a multi-page document, you can collate the output. For
example, if you are making three single-sided copies of a six-page document, the copies are
printed in this order when you select collated:
1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6
If you select uncollated, the copies are printed in this order:
1, 1, 1, 2, 2, 2, 3, 3, 3, 4, 4, 4, 5, 5, 5, 6, 6, 6
To select a collating option:
1. On the control panel, press the Copy button.
2. Select
Collated, and then press the OK button.
3. Select
Uncollated or Collated, and then press the OK button.
Note: The factory default is Uncollated.
Output Quality
The following table describes the two output-quality modes:
To change the output-quality mode:
1. On the control panel, press the Copy button.
2. Select
Output Quality, and then press the OK button.
3. Select either
Standard or Enhanced, and then press the OK button.
Note: The factory default is Standard.
Output-Quality Mode Type of Copy Job
Standard General-purpose mode for copies. Produces crisp,
bright copies at high speed.
Enhanced Best mode for high quality copies. Produces very
smooth accurate colors. This mode takes longer to
process and print than Standard mode.
To Next Page
Loading...
Need help?
General
