Adjusting Copying Options
Phaser® 6180MFP Multifunction Printer
6-11
Setting the Copy Margins
You can set the copy margins and enable the margin settings for all copies, or you can enable
them for individual copy jobs only.
Setting the Margins
1. On the control panel, press the System button.
2. Select
Default Settings, and then press the OK button.
3. Select
Copy Defaults, and then press the OK button.
4. Select
Margin Width, and then press the OK button.
5. Select the margin that you would like to change, and then press the OK button.
6. Use the Up Arrow or Down Arrow button to adjust the margin, and then press the
OK button.
7. Repeat the steps for other margins, and then press the Exit button.
8. You can now use the margin settings for a single copy job, or you can enable the margin
settings for all jobs. To use the margin settings for a single job, see Copying with the
Margin Settings Enabled for a Single Job on page 6-11. To enable the margin settings for
all copy jobs:
a. Select
Margin, and press the OK button.
b. Select
On, and then press the OK button.
The Margin setting is now enabled for all copy jobs.
Note: The margin width is only enabled when copying from the document glass.
Copying with the Margin Settings Enabled for a Single Job
1. Place the document to be copied on the document glass.
2. On the control panel, press the Copy button.
3. Select
Margin, and then press the OK button.
4. Select
On, and then press the OK button.
5. Press the Start button to begin copying.
To Next Page
Loading...
Need help?
General
