Error Troubleshooting
Phaser 6600 and WorkCentre 6605 Xerox Internal Use Only
Service Manual
2-28
10. Press the OK button, and check the operation sound.
11. Press the Back button to stop the Regi Clutch operation.
12. To stop the Main Motor (Half) operation, use the [ ] button to select [071-002], and then press
the Back button.
13. To set LVPS 24V to Off, use the [ ] button and select [041-001], and then press the Back button.
14. Press the Back button to return to the [Printer Diag] screen.
15. Exit Service Mode. See “How to Exit Service Mode” on page 2-10.
NVM Settings
You can access the NVM (IOT EEPROM) using the keys on the touch panel.
The following functions are provided.
• Reading and writing of the data in the IOT NVM
• Saving the IOT NVM information to ESS
• Returning all NVM information saved in ESS to the IOT NVM
NVM Read and Write (Edit NVM)
NVM Edit allows you to read or write the IOT NVM.
CAUTION: NVM Read and Write (NVM Edit) is for changing settings peculiar to the device, and
therefore requires you a precise attention, otherwise you might lose the essential setting of the
printer or give the printer an unrecoverable failure.
Procedure
1. Enter Service Mode. See “How To Enter Service Mode” on page 2-8.
2. Confirm that the [Printer Diag] is selected, and then press the OK button.
Monitor Test
071-010 READY
Monitor Test
071-010 EXEC
Monitor Test
071-010 READY
Monitor Test
071-002 READY
Monitor Test
041-001 READY
To Next Page
Loading...
Need help?
General
Weight and Dimensions
