Cleaning the Machine
17
Cleaning the Machine
The cleaning instructions are specific to each part of the machine, such as the machine
exterior, Document Cover, Document Glass, Film, Narrow Glass Strip, Document
Feeder Roller, and Corotron Wire.
This section describes how to clean each component of the machine.
Cleaning the Exterior
The following describes how to clean the exterior of the machine.
NOTE: Always switch off the power to the machine, and unplug the power cord before
cleaning any part of the machine. Cleaning the machine with the power on may cause
an electric shock.
NOTE: Do not use any volatile liquids on the machine such as benzene and paint
thinner, or insect repellent as these may discolor, deform, or crack the machine
exterior.
NOTE: Cleaning the machine with an excessive amount of water may cause the
machine to malfunction, or damage documents being copied.
1.
Wipe the exterior with a soft cloth
moistened with water.
NOTE: Do not use cleaning agents other
than water or neutral detergent.
NOTE: If dirt does not come off easily,
gently wipe it with a soft cloth moistened
with a small amount of neutral detergent.
2.
Wipe off any excess water with a soft
cloth.
Cleaning the Document Cover and Document Glass
If the Document Cover and Document Glass are dirty, streaks or smears may appear
on copies, or the machine may not properly detect the size of the original documents.
The following procedure describes how to clean the Document Cover and the
Document Glass.
NOTE: Do not use benzene, paint thinner, or other organic solvents. Doing so might
damage paint or coating on plastic parts.
NOTE: Cleaning the machine with an excessive amount of water may cause the
machine to malfunction, or damage documents being copied.
To Next Page
Loading...
Need help?
General
