2 Maintenance
20
2. Pull the Corotron Wire back and forth
several times.
3. Close the Front Cover.
Moving the Machine
This section describes how to move the machine to another location.
Before moving the machine, always secure the position of the scanner carriage.
1. Hold down the <Reduce/Enlarge>
button for four seconds, and while
holding down the <Reduce/Enlarge>
button, press the <Stop> button.
The scanner carriage moves to the
locked position.
While the scanner carriage is moving,
[run] appears in the Display. When the
carriage completely moves to the
locked position, [OFF] appears blinking
in the Display.
NOTE: While the scanner carriage is
locked, all indicators go off and no button is
available on the Control Panel, and the
machine does not process any jobs.
2. Switch off the machine.
NOTE: If the machine is switched off, all the scanned data stored in the mailboxes is
deleted. For information on how to switch off the machine, refer to the Product
Overview chapter in the User Guide.
3. Remove the screw cover from the right
side of the machine.
<Stop> button
<Reduce/Enlarge> button
To Next Page
Loading...
