Cleaning the Machine
19
The following procedure describes how to clean the Document Feeder Roller.
NOTE: Do not use benzene, paint thinner, or other organic solvents. Doing so may
damage paint or coating on plastic parts.
NOTE: Cleaning the machine with an excessive amount of water may cause the
machine to malfunction, or damage documents being copied.
1.
Pull up the latch to open the Document
Feeder Cover completely.
2.
Turn the Document Feeder Roller to
clean it with a soft cloth moistened with
water.
NOTE: Do not use cleaning agents other
than water or neutral detergent.
NOTE: Use a firmly wrung cloth to avoid
water drops falling onto the machine. If
water gets into the machine, it may cause
the machine to malfunction.
NOTE: If dirt does not come off easily, gently wipe it with a soft cloth moistened with a
small amount of neutral detergent.
3.
Close the Document Feeder Cover until it clicks into place.
Cleaning the Corotron Wire
If any streaks, black lines, or smears appear on the output copies, cleaning the
Corotron Wire may help resolve the problem.
The following procedure describes how to clean the Corotron Wire.
1.
Open the Front Cover.
To Next Page
Loading...
