SNMP Configuration
49
4.
If prompted, enter the System Administrator user ID and passcode, and click [OK].
NOTE: Click the [Reboot Machine] button when it is displayed. If the [Reboot
Machine] button fails to be displayed, click the [Status] tab and then click the [Reboot
Machine] button.
NOTE: If the machine is rebooted, all scanned data stored in the mailboxes will be
deleted.
Computer Setup
Before starting Computer Setup, make sure that the USB cable is disconnected from
the computer.
Then perform the following steps.
1.
Refer to the PCL Print Driver CD-ROM, and install the print drivers for the
machine on the computer that will be sending jobs to the machine.
2.
Connect the USB cable to the machine and the computer.
3.
Continue with
Test Print on page 49
.
Test Print
To make sure that the machine has been installed on the USB port correctly, submit a
test print from each client computer. Perform the following steps.
1.
Open a document on the computer.
2.
Select the machine as the printer.
3.
Print the document on the machine and verify that it prints correctly.
4.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to
Problem Solving on page 75
.
SNMP Configuration
This section describes how to configure the SNMP settings when accessing the
machine via SNMP.
1.
Open your web browser, and enter the machine's IP address in the [Address] box
to access CentreWare Internet Services.
2.
Click the [Properties] tab.
3.
Click the [Connectivity] folder, and then [Port Settings].
4.
Select the [Enabled] check box for [SNMP] to enable the SNMP port.
5.
Click [Apply].
6.
If prompted, enter the System Administrator user ID and passcode, and click [OK].
NOTE: By default, the System Administrator user ID is "11111" and its passcode is not
set.
7.
On the collapsible menu of the Menu Panel, click the [Protocols] folder, and then
[SNMP Configuration].
To Next Page
Loading...
Need help?
General
