43
6 Printer Environment Settings
This chapter describes how to set up the printing environment for the machine.
The following information is provided in this chapter:
TCP/IP (LPD or Port9100) – page 43
USB Port – page 47
SNMP Configuration – page 49
TCP/IP (LPD or Port9100)
This section explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided:
Information Checklist – page 43
TCP/IP (LPD or Port9100) Environments – page 44
TCP/IP (LPD or Port9100) Installation – page 44
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
If problems are encountered during machine setup, refer to
Problem Solving on
page 75
.
Item By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the Glossary in the User Guide for additional information about
the gateway address and subnet mask, if needed.
Customer
Test the machine to make sure that it is fully installed and functioning
correctly.
Customer
Install the print driver. Customer
To Next Page
Loading...
