5 Machine Status
40
General Setup Configuration Displays information such as the memory capacity,
available printer language, and installed software.
•Memory
Displays the size of the installed memory, and
amount of memory used for each port/protocol.
•Available PDL
Lists the printer language used by the machine and
its version.
•Software
Displays the version of software (firmware) installed
on the machine.
Job Management • Job Deletion
Allows you to set whether to allow all users or only
the System Administrator to delete jobs.
Paper Tray
Attributes
•Trays
Lists the paper trays installed.
• Paper Size
Lists the paper size set for each tray.
•Priority
Allows you to set the priority for specified paper
trays.
Paper Size
Settings
Allows you to specify the paper size table. You can
select from [A/B Series (8K/16K)], [Inch Series
(8.5 x 13")], [Inch Series (8.5 x 13.4")], and [Inch
Series].
NOTE: Depending on the paper size table the machine
is programmed to use, the document sizes that can be
detected by the Document Feeder change. Refer to
Document Sizes Detectable by the Document Feeder
on page 121
.
Unit Settings Allows you to specify [Inches] or [Millimeters] as the
unit for entering document or scan sizes.
Power Saver
Settings
• Low Power Mode Time-Out
Allows you to specify the time-out period before the
machine enters the Low Power Mode from the last
user operation.
• Sleep Mode Time-Out
Allows you to specify the time-out period before the
machine enters the Sleep Mode from the last user
operation.
NOTE: You must specify a longer time period for the
Sleep Mode than for the Low Power Mode.
Feature Setting items
To Next Page
Loading...
Need help?
General
