Xerox WorkCentre 5020 - Page 62

7 Scanner Environment Settings
62
4. Click [Apply].
Resolution Specify the scan resolution for the documents
to be scanned.
• [200 x 200 dpi] (Default)
• [300 x 300 dpi]
• [400 x 400 dpi]
• [600 x 600 dpi]
Reduce / Enlarge Preset % Select the preset enlargement/reduction ratio.
•[A3
JA5/11x17J5.5x8.5(50.0%)]
•[B4
JA5(57.7%)]
•[A3
JB5(61.2%)]
•[11x17
J8.5x11/8.5x11J5.5x8.5(64.7%)]
•[A3
JA4/B4JB5(70.7%)]
• [8.5x14
J8.5x11/A3J8.5x13(78.5%)]
•[B4
JA4/B5JA5(81.6%)]
•[A3
JB4/A4JB5(86.6%)]
•[A4
J8.5x11/A3J11x17(94.0%)]
• [8.5x11
JA4/11x17JA3(97.3%)]
• [100%] (Default)
•[B4
JA3/B5JB4(115.4%)]
•[A4
JB4/A5JB5(122.5%)]
• [8.5x13
JA3(127.3%)]
• [5.5x8.5
J8.5x11/8.5x11J11x17(129.4%)]
•[A4
JA3/B5JB4(141.4%)]
• [5.5x8.5
J8.5x14(154.5%)]
•[B5
JA3(163.2%)]
•[A5
JB4(173.2%)]
•[A5
JA3/5.5x8.5J11x17(200%]
Variable % Specify a desired enlargement/reduction ratio.
The value can be specified within the range of
50 - 200% in 1% increments.
Edge Erase Top & Bottom Allow you to erase unwanted marks from each
edge of scanned documents.
Set the top and bottom margins within the
range of 0 - 50 mm (0 - 2.0 inches)*.
(Default: 2mm/0.1 inches*)
*The measurement unit will depend on the
setting in [Unit Settings] on the [Properties]
tab.
Left & Right Allow you to erase unwanted marks from each
edge of scanned documents.
Set the left and right margins within the range of
0 - 50 mm (0 - 2.0 inches)*.
(Default: 2mm/ 0.1 inches*)
*The measurement unit will depend on the
setting in [Unit Settings] on the [Properties]
tab.
Parameter Value