ADPRO Presidium by Xtralis Installation and User Manual
Doc. 12384_05 41
Table 4: Network Connection Indicators
Note: ALWAYS consult with the IT or Network Manager for the network BEFORE
physically connecting Presidium to the network.
3.11 Status LEDs
The are two LEDs displaying the unit’s condition: Power and Status.
• Power LED: The Power LED illuminates green when power is supplied to the Presidium.
• Status LED: The Status LED illuminates red when a fault has been detected in the
Presidium (the fault relay is also activated) or during bootup.
The Presidium Mini also has 2 additional LED indicators to display which channel is in alarm.
Port Link Status Network Speed LED Displays
10/100/1000 LAN1
and LAN 2 ports
(on rear panel)
Down Any All LEDs off
UP 10 Mbps RH Dual coloured speed LED = OFF
LH Green Activity LED = LINK/ACTIVITY (ON if link up or
flashing if link up and data transfer activity).
UP 100 Mbps RH Dual coloured speed LED = GREEN
LH Green Activity LED = LINK/ACTIVITY (ON if link up or
flashing if link up and data transfer activity).
UP 1000 Mbps RH Dual coloured speed LED = Yellow
LH Green Activity LED = LINK/ACTIVITY (ON if link up or
flashing if link up and data transfer activity).
10/100 SETUP
port on front fascia
Down Any All LEDs off
UP 10 Mbps LH GREEN LED = OFF
RH GREEN LED = LINK/ACTIVITY (ON if link up or
flashing if link up and data transfer activity).
UP 100 Mbps LH GREEN LED = ON
RH Green LED = LINK/ACTIVITY (ON if link up or
flashing if link up and data transfer activity).
To Next Page
