LUBRICATION INTERVALS
Unit: km (miles)
item
Remarks
Type
(Recommended lubricants)
SOO (300)
initial
1,500 (1,000)
3,000 (2,0001
Thereafter every
3,000 (2poo)
6
poo
(4,0001
Engine oil
0
0
Replace/Warm engine before
draining
See page 2-23
5,000 (3,000)
Replace/After installing start
engine check oil leaks
Oil filter
0
5,000 13,000)
10,000 (6,000)
0
Final gear oil
Replace
SAE 80 API GL-4 Hypoid gear all
10,000 16,000)
Hydraulic brake fluid
reserve
Control/Meter cables
Use new fluid only
Apply thoroughly
SAE lOW 30 motor oil
DDT #3
check
check
0
check
0
check
0
Throttle grip/Housing
Apply lightly
Lithium base
0
Rear arm pivot bearing
Brake pedal shaft
Apply grease fully or yearly
Apply lightly
Medium-weight wheel bearing grease
SAE 10W 30 motor all
12,000 (8,000)
0
Change pedal shaft/brake
and clutch lever pivot
Apply
lightly
SAE 10W 30 motor oil
0
0
Center and side stand
pivots
Apply lightly
SAE 10VV 30 motor oil
0
0
Front forks
Drain completely/Replace —
Check specifications
SAE 10W 30 type SE motor oil
0
check
Steering bearins
Inspect thoroughly/Pack
moderately
Medium-weight wheel bearing grease
12,000 (8,000)
Speedometer gear hosing
Inspect thoroughly/Pack
moderately
Litium base grease
12poo
(8,000)
Coolant
NOTE:

Brake fluid replacement:
1.
When disassembling the master cylinder or caliper cylinder, replace the brake fluid.
Normally check the brake fluid level and add the fluid as required.
2.
On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two
years.
3.
Replace the brake hoses every four years, or if cracked or damaged.
Replace
See page 2-27
Every two years
To Next Page
Loading...
Need help?
General
