Main Circuit Terminal Functions.....................50
Main Circuit Terminal Power Supply.................52
Main Circuit Terminal Wiring ..................27, 236
Main Frequency Reference ..........................63
Maintenance .................................159, 160
Master Speed Reference Lower Limit .............. 203
Max Output Frequency............................ 205
Max Voltage ..................................... 205
MEMOBUS/Modbus Communication Error ...124, 125,
126, 134
MEMOBUS/Modbus Communications Test Mode
Complete ........................................ 137
MEMOBUS/Modbus Communications Test Mode
Error............................................. 137
MEMOBUS/Modbus Error Code .................. 217
Memobus/Modbus Error Code ..................... 109
MEMOBUS/Modbus Test Mode Complete ......... 125
Mid Output Frequency ............................ 205
Mid Output Frequency Voltage .................... 205
Mid Output Voltage A ............................ 121
Minimum Output Frequency...................149, 205
Minimum Output Frequency Voltage .............. 205
Minimum Output Voltage ......................... 121
Minor Alarms .................................... 124
Minor Faults .................................123, 124
Modes .............................................78
Momentary Power Loss Operation Selection ........ 211
Motor Does Not Operate When an
External Run Command
is Input .......................................... 149
Motor Does Not Operate When the RUN Button on the
Digital Operator is Pressed ........................ 149
Motor Does Not Rotate............................ 143
Motor Hunting and Oscillation Control Parameters
.................................................. 121
Motor Hunting Occurs When Operating With a Light Load
.................................................. 147
Motor is Too Hot ................................. 145
Motor Line-to-Line Resistance.................103, 205
Motor No-Load Current .......................103, 205
Motor Overload ..............................124, 130
Motor Overload Protection Selection ...... 106, 210, 239
Motor Overload Protection Time..........106, 210, 239
Motor Parameters................................. 103
Motor Protection Function......................... 130
Motor protection operation time ................... 107
Motor Rated Current ................ 103, 106, 205, 238
Motor Rated Slip .............................103, 205
Motor Rotates After the Drive Output is Shut Off ... 148
Motor Rotates Faster Than the Frequency Reference
.................................................. 146
Motor Rotates in One Direction Only............... 145
Motor Stalls During Acceleration or With Large Loads
.................................................. 146
Motor Stops During Acceleration or When a Load is
Connected........................................ 150
Motor Wiring ......................................52
Multi-Function Analog 1 (Terminal AM Monitor
Selection) ........................................ 209
Multi-Function Analog Outputs .................... 104
Multi-Function Contact Input ........................97
Multi-Function Contact Output .................... 103
Multi-Function Digital Input Terminal S1 Function
Selection ......................................... 206
Multi-Function Digital Input Terminal S2 Function
Selection ......................................... 206
Multi-Function Digital Input Terminal S3 Function
Selection ......................................... 206
Multi-Function Digital Input Terminal S4 Function
Selection ......................................... 206
Multi-Function Digital Input Terminal S5 Function
Selection ......................................... 206
Multi-Function Input Selection Error ............... 139
Multi-Function Input Setting Error ................. 125
Multi-Step Speed Operation (4-Step Speed)...........96
Multi-Step Speed Reference ....................... 206
P
Parameter Range Setting Error ..................... 139
Parameter Setting Range Error ..................... 125
Parameter Settings ..................................82
PASS ........................................125, 137
Password 1 ....................................... 199
Password 2 ....................................... 199
Password Settings ................................ 116
Peak Hold Current ............................110, 218
Performance Life ................................. 159
Peripheral Devices Affected by Drive Operation .... 150
PF ...........................................124, 132
Phase Order Selection............................. 200
Index
244
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
2/6/2008-14:44
To Next Page
Loading...
Need help?
General
