YASKAWA OYMC V1000

A.2 Parameter Table
YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual 335
Parameter List
A
4D
OH Pre-alarm Time
Limit
Closed: OH Pre-alarm time limit is passed. O O O 171
90 to 92
FBD’s Digital Outputs
1 to 3
Reserved for FBD’s digital output functions. O O O 172
100 to
14D
H2 Parameter Functions
Reversed Output
Switching of 0 to 92
Reverse the output switching of the multi-function output
functions. Set the last two digits of 1 to reverse the output
signal of that specific function.
Examples:
Setting “108” reverses the output of “During baseblock,” which is
setting value 08.
Setting “14A” reverses the output of “During KEB operation”,
which is setting “4A”.
OOO172
No. Name Description Range Def.
Control
Mode
Addr.
Hex
Pg.
V/f
O
LV
P
M
H3: Analog Inputs
Use H3 parameters to set the multi-function analog input terminals.
H3-01
Terminal A1 Signal
Level Selection
Sets the input level for terminal A1.
0: 0 to +10 V (lower limit)
1: 0 to +10 V (no lower limit)
0, 1 0 A A A 410 172
H3-02
Terminal A1 Function
Selection
Sets the function of terminal A1.
When terminal A1 is not used or is used as a
through terminal, this parameter must be set to
“F”.
0 to 31
<40>
0AAA434173
H3-03
<22>
Terminal A1 Gain
Setting
Sets the level of the input value selected in H3-
02 when 10V is input at terminal A1.
-999.9 to
999.9
100.0
%
AAA 411 174
H3-04
<22>
Terminal A1 Bias
Setting
Sets the level of the input value selected in H3-
02 when 0V is input at terminal A1.
-999.9 to
999.9
0.0% A A A 412 174
H3-09
Terminal A2 Signal
Level Selection
Sets the input signal level for terminal A2.
0: 0 to +10 V (with lower limit)
1: 0 to +10 V (no lower limit)
2: 4 to 20 mA
3: 0 to 20 mA
0 to 3 2 A A A 417 176
Switch between current or voltage
inputs by using DIP switch S1-2
switch on the terminal board.
H3-10
Terminal A2 Function
Selection
Sets the function of terminal A2.
When terminal A2 is not used or is used as a
through terminal, this parameter must be set to
“F”.
0 to 31
<40>
0AAA418176
H2 Multi-Function Digital Output Settings
H2-
Setting
Function Description
Control
Mode
Pg.
V/f
O
LV
P
M