YASKAWA SGMPS - 11.2 List of Parameters

11 Appendix
11.2.1 Utility Functions
11-8
11.2 List of Parameters
11.2.1 Utility Functions
The following list shows the available utility functions.
{: Avaiable ×: Not available
∗ The following functional restrictions apply to the Panel Operator.
Note 1. A setting may be write-prohibited if the Panel Operator displays "no_oP" when any of the above utility function
is executed. Refer to 7.12 Write Prohibited Setting (Fn010).
2. When utility functions which cannot be operated from the panel operator are executed from the panel operator,
"no_oP" is displayed.
Parameter
No.
Function
Operation
from the
Panel
Operator
Operation from
the Digital
Operator or
SigmaWin+
Reference
Section
Fn000 Alarm traceback data display
{{
7.2
Fn002 JOG mode operation
{{
7.3
Fn003 Origin search
{{
7.4
Fn004 Program JOG operation
{{
7.5
Fn005 Initializes parameter settings
{{
7.6
Fn006 Clears alarm traceback data
{{
7.7
Fn008 Absolute encoder multi-turn reset and encoder alarm reset
{{
5.9.5
Fn009 Automatic tuning of analog (speed, torque) reference offset
{{
5.3.2
5.5.2
Fn00A Manual servo tuning of speed reference offset
{{
5.3.2
Fn00B Manual servo tuning of torque reference offset
{{
5.5.2
Fn00C Offset Adjustment of analog monitor output
{{
7.8
Fn00D Gain Adjustment of analog monitor output
{{
7.9
Fn00E Automatic offset-adjustment of motor current detection signal
{{
7.10
Fn00F Manual offset-adjustment of motor current detection signal
{{
7.11
Fn010 Write prohibited setting
{{
7.12
Fn011 Checks servomotor models
{{
7.13
Fn012 Software version display
{{
7.14
Fn013
Multi-turn limit value setting change when a multi-turn limit
disagreement alarm occurs
{{
5.9.8
Fn014 Resets configuration error of option module
{{
7.15
Fn01B Initializes vibration detection level
{{
7.16
Fn01E SERVOPACK and servomotor ID display
× {
7.17
Fn01F Display of servomotor ID for feedback option
× {
7.18
Fn020 Origin setting
× {
7.19
Fn030 Software reset
{{
7.20
Fn200 Tuning-less level setting
{{
6.2.2
Fn201 Advanced autotuning
× {
6.3.2
Fn202 Advanced autotuning by reference
× {
6.4.2
Fn203 One-parameter tuning
{* {
6.5.2
Fn204 Anti-resonance control adjustment function
× {
6.6.2
Fn205 Vibration suppression function
× {
6.7.2
Fn206 EasyFTT
{{
7.21
Fn207 Online vibration monitor
{{
7.22