Phase Compensation Signal
The instrument generates the following square wave signal from the COMP signal output terminal.
Frequency:
1 kHz ± 1%
Computation: 1 V ± 10 %
Differences in the Waveform due to the Phase Correction of the
Probe
Correct waveform
Too much adjustment
(increased gain in the high
frequency band)
Not enough adjustment
(reduced gain in the high
frequency band)
Notes about Using Probes with the Frequency Module (701280
(FREQ))
You cannot perform phase correction on a probe connected to the frequency module. To use a probe
with the frequency module, first perform phase correction on the probe using another module.
3.6 Correcting the Probe Phase
3-21
IM DL850-03EN
Making Preparations for Measurements
To Next Page
Loading...
