YOKOGAWA UM33A - 4.2 How to Set Parameters

4-4
IM 05P03D21-01EN
4.2 HowtoSetParameters
The following operating procedure describes an example of setting alarm setpoint (A2).
Operation
1.
Hold down the PARA key for 3 seconds in the Operation Display to call up the [AL]
Menu Display.
8
2.
Press the SET/ENTER key to display the [A1] Parameter Setting Display.
8
3.
Press the Down arrow key to display the [A2] Parameter Setting Display.
8
4.
Press the SET/ENTER key to blink the setpoint.
8
5.
Press the Up or Down arrow key to change the setpoint.
(Change the setpoint using the Up/Down arrow keys to increase and decrease the
value and the Left/Right arrow keys to move between digits.)
8