Accessories
146
NOTE: See Power Supply on page 152 for information on setting up the power supply.
By default, the device includes an interface connector. If the interface connector is removed for USB Type C
cable connectivity, then it must be replaced before charging or receiving an Ethernet IP address if placed in a
cradle.
3. Plug to power supply into an power outlet.
Disconnecting the Rugged Charge/USB Cable
To disconnect the Rugged Charge/USB Cable from the device:
1. Rotate the device to one side.
2. Push the Rugged Charge/USB Cable to the other side.
3. Remove the device from the Rugged Charge/USB Cable.
MN-003834-01ENa_tc52-android-10-ug-en.book Page 146
To Next Page
Loading...
