Data Capture
78
6. Align the NFC icon on the Ring Scanner with the NFC antenna on the device.
The Ring Scanner Status LED blinks blue indicating that the Ring Scanner is attempting to establish
connection with the device. When connection is established, the Status LED turns off and the Ring Scanner
emits a single string of low/high beeps.
A notification appears on the device screen and the icon appears in the Status bar.
Figure 36 Align NFC Antennas (RS6000 shown)
Pairing Using Simple Serial Interface
To pair the Ring Scanner with the device using SSI.
1. Swipe up from the bottom of the Home screen and touch .
Figure 37 Bluetooth Pairing Utility
NFC Logo
MN-003834-01ENa_tc52-android-10-ug-en.book Page 78
To Next Page
Loading...
