Zebra TC52 Series - Getting Started and Device Usage; Initial Setup and Device Features

15
Getting Started
Introduction
This section provides information for getting the device up and running for the first time.
Unpacking
1. Carefully remove all protective material from the device and save the shipping container for later
storage and shipping.
2. Verify that the following were received:
• Touch computer
• >
15.48 Watt hours (typical) / > 4,150 mAh PowerPrecision+ Lithium-ion battery
• Regulatory Guide.
3. Inspect the equipment for damage. If any equipment is missing or damaged, contact the Customer
Support center immediately.
4. Prior to using the device for the first time, remove the protective shipping film that covers the scan
window, display and camera window.
MN-003834-01ENa_tc52-android-10-ug-en.book Page 15