Zeiss EVO - Page 17

ZEISS 2 Safety | 2.4 Warning Labels and Lights
Position and Figure of the Safety La-
bel
Description
9
At the gun head
Risk of burn
Before opening the gun leave the gun and fila-
ment cool down for 15 minutes after switching
off the microscope.
10
At the rear side of the plinth
Radiation hazard
Do not remove any parts.
Observe local safety and X-ray protection regula-
tions.
Service only through authorized personnel.
Reorder no. 347800-0033-000-06en
11
At the rear side of the plinth
Caution
X-rays are produced in this Scanning Electron Mi-
croscope!
The acceleration voltage is limited to 30kV.
Observe local safety and X-ray protection regula-
tions.
Order no. 346000-0088-000
12
At the rear side of the plinth
Contact may cause burn or electric
s
hock. Only authorised service
Staff is allowed to service the
equipment.
Disconnect power before opening.
Hazardous voltage inside
WARNING
347800-0033-000-03en
Hazardous voltage inside
Contact may cause burn or electric shock. Only
authorized service Staff is allowed to service the
equipment.
Disconnect power before opening.
Reorder no. 347800-0033-000-03en
14
At the rear side of the plinth
WARNING
High leakage current
347800-0033-000-07en
En
sure proper grounding.
Do not operate the electron
microscope without a separate
ground connection.
High leakage current
Ensure proper grounding.
Do not operate the electron microscope without
a separate ground connection.
Reorder no. 347800-0033-000-07en
15
At the rear side of the plinth
Risk of electrical shock
Residual voltage at the mains plug after unplug-
ging.
Wait at least 5 s after unplugging the mains plug
before touching the pins of the mains plug.
Reorder no. 344700-0033-000-11en
Instruction Manual ZEISS EVO | en-US | Rev. 10 | 354706-0780-006 17