6 Options
6-8 NetPath 100 User’s Manual - Installation Guide 980-001-0210G
June
1999
Parameter
Setting
This section describes the additional screens and parameters used to configure the
ISDN Adapter option. There are also some field changes on the System View Screen
specific to the ISDN Adapter option. The ISDN configuration screens are; ISDN
Adapter Configuration Screen and the Backup/On-Demand Configuration Screen. All
basic unit screens are described in Section 4, “Operation,” in this manual.
System View
Screen
The System View screen for NetPath 100 with ISDN Adapter is shown in Figure 6-4.
Fi
ure 6-4 S
stem View Screen with ISDN Adapter Option
The ISDN-specific fields on the System View screen are as follows:
Base S/W - Software revision number currently operating the unit.
The first two-digit number indicates the unit’s feature set, the second indicates
the base software revision, and the last indicates minor revision level.
An Alpha character at the end of this field indicates the option type installed, if
any. In the example shown in Figure 6-4 above, i = ISDN Adapter option.
************************** NetPath 100 - System View ***************************
Name: F@43802 Base S/W: 07.01.86i
Location: Fair Lawn, N.J. S/N: 001812
Contact: J. Jones
System High Speed Interface Status
Test/Fault: DTR: On
RTS: On
Power: On
Modem Status Interface: ITU-V35
Fault: ISDN Backup: Armed
Connection:
On-Demand Interface Status
Aux Port Status DTR: On
Aux1 DTR: Off RTS: On
Aux2 DTR: Off Interface: ITU-V35
ISDN Demand: Armed
DevConfig[DC] CsuConfig[CC] FrameConfig[FC] PvcConfig[PC] MonConfig[MC]
DevTest[DT] CsuStats[CS] FrameStats[FS] PvcStats[PS] MonStats[MS]
SnmpConfig[SC] TrapConfig[TC] IsdnConfig[IC] BkupConfig[BC] IsdnTest[IT]
Help[?] Logout[LO] AutoUpdate[AU] HubConfig[HC]
>
To Next Page
Loading...