Appendix
A-8 NetPath 100 User’s Manual - Installation Guide 980-001-0210G
June
1999
Line
n
/B
n
(ISDN)
Line n/Bn shows the highest priority fault, test or status currently detected for each
ISDN Line (1-4) and B-Channel (1-2). This is displayed on the ISDN Status / Test
screen.
NOTE: An ISDN switch will return a “Cause Code” indicating a status for the latest
connection attempt. A “Ready” or “Failed” status and the latest returned code
number are displayed in this field for each configured B-Channel. A list of
codes and causes are shown in Table 9 on the following page.
Table 1-8 Line
n
/B
n
(ISDN)
Displa
Description
ISDN Adapt Fault The ISDN hardware has failed.
ISDN Line Failure The ISDN line of this B-Channel is faulty.
ISDN SPID Failure An invalid or incorrect SPID has been entered for this B-Channel.
B1 SPID Failure A B2-Channel cannot operate due to a SPID failure on its associated B1-Channel.
LoopUp LoopUp connection in place.
Connecting Connection is being established.
Online Connection in place.
Online-mmmm
(Applies to MLPPP
only)
Connection in place.
“mmmm” indicates the last connection status, see Table 10
Failed-xxx Retry attempts exhausted.
“xxx” indicates the latest Cause Code (See Note below.)
Failed-xxx-mmmm
(Applies to MLPPP
only)
Retry attempts exhausted.
“xxx” indicates the latest Cause Code (See Note below.)
“mmmm” indicates the last connection status, see Table 10 for codes.
Ready-xxx Default state if not disabled and no failure exists.
“xxx” indicates the latest Cause Code (See NOTE below.)
Ready-xxx-mmmm
(Applies to MLPPP
only)
Default state if not disabled and no failure exists.
“xxx” indicates the latest Cause Code (See NOTE below.)
“mmmm” indicates the last connection status, see Table 10 for codes.
To Next Page
Loading...